Pump Maintenance Services
Mechanical seals, bearings, alignment and fault finding for industrial pumps across SE QLD: servicing, breakdown repairs and shutdown support.
Request a Quote or Callback
Tell us what's going on and we'll get back to you.
Enquiry received
Thanks, we'll be in touch shortly. For urgent breakdowns call 0472 876 711.
Sorry, that didn't send. Please call 0472 876 711 or email Service@oms-au.com.
Pumps Back On Line, Properly
A pump rarely fails on its own. A seal weeps, a bearing runs hot, an alignment drifts, and the failure follows from there. We service and repair industrial pumps the way rotating equipment should be handled: find the root cause, fix it to spec, and get the duty point back where it belongs.
We work centrifugal, slurry, multistage and positive-displacement pumps across water and wastewater, process, quarry and food sites: mechanical seal replacement, bearing renewal, shaft and coupling alignment, wear-ring and clearance checks, and a run-up to confirm it's running true before it goes back into service.
On a shutdown we'll work your pumps through the scope on schedule; on a breakdown we'll find the cause. Either way it comes back aligned and recorded, not just bolted together.
Pump work we handle
- Mechanical seal replacement
- Bearing inspection & renewal
- Shaft & coupling alignment
- Run-up checks after repair
- Wear-ring & clearance checks
- Impeller & casing wear repairs
- Seal-support & flush systems
- Breakdown & shutdown support
Why Seals & Alignment Decide Pump Life
Seals
Most pump downtime starts at the seal. Correct selection and fitting for the duty is the difference between months and years of run time.
Alignment
A few thou of misalignment shortens bearing and seal life dramatically. We align pump to motor and record the readings.
Run-up Checks
Noise, heat and leak checks on run-up catch early bearing and seal problems before the pump goes back into service.
From Fault to Back in Service
Call with the symptoms
Weeping seal, noise, lost head, tripping on overload. Tell us what it's doing and we'll read the urgency.
Diagnose on site or strip in the workshop
We find the real cause, seal, bearing, alignment, wear or system, rather than swapping parts and hoping.
Repair, align, verify, report
Rebuilt to spec, aligned, run up and checked and handed back with the numbers recorded for your file.
Pairs Well With
Pump Maintenance Questions
Why do our pump seals keep failing?
Repeat seal failures usually trace to alignment, the wrong seal for the duty, or a dry-run or flush problem, not the seal itself. We look at the cause so the replacement actually lasts.
Can you align pumps to motors on site?
Yes. We align pumps to motors on site and record the readings. Correct alignment is one of the biggest single wins for bearing and seal life.
Do you handle slurry and process pumps as well as water?
Yes, centrifugal, slurry, multistage and positive-displacement pumps across water and wastewater, process, quarry and food applications.
Can pump overhauls be scheduled into a shutdown?
Yes. Planning pump work into a shutdown is far cheaper than a mid-run failure. We scope it and resource it to your window.
Pump down or weeping?
Seals, bearings and alignment done properly: on site or in the workshop, across SE QLD.
Or email Service@oms-au.com