Laser alignment, balancing, vibration analysis and overhaul of pumps, fans, compressors and gearboxes across industrial and power plant in SE QLD.
Pumps, fans, blowers, compressors, gearboxes and the shafts and couplings that join them — rotating equipment is where small errors get expensive. A coupling out by a few thou, a bearing run past its life, an unbalanced fan: each shows up as vibration, heat and noise long before it shows up as a failure, if someone's measuring.
OMS provides rotating equipment maintenance across industrial, processing and power generation plant on the Sunshine Coast. Precision laser alignment, dynamic balancing, vibration analysis, bearing and seal replacement, and full overhauls to OEM specification. The same discipline we've applied to turbine and process-plant rotating gear, brought to local facilities.
Most rotating-equipment failures are avoidable. Misalignment and imbalance destroy bearings and seals; contaminated or wrong-grade oil destroys gearboxes. Get the alignment, balance and lubrication right and the same machine runs for years longer.
Laser shaft alignment on pump-and-motor and drive trains — the single biggest lever on bearing and seal life.
Dynamic and on-site balancing of fans, impellers and rotating assemblies to cut vibration at the source.
Measuring and interpreting vibration to catch bearing, imbalance and looseness faults early.
Correct fitment and replacement of bearings and mechanical seals — the components that fail when alignment is wrong.
Full strip, inspect and rebuild of pumps, fans, compressors and gearboxes to OEM spec.
Right grade, right amount, right interval — plus oil analysis to read gearbox and bearing health.
Yes. Precision laser alignment on pump, fan and drive trains is core to what we do. Good alignment is the cheapest way to extend bearing and seal life, and it's where a lot of 'mystery' vibration comes from.
Yes. We carry out dynamic and on-site balancing to bring vibration back within limits without pulling the whole assembly out, where the machine allows it.
Yes. Full strip-down, inspection, bearing and seal replacement and rebuild to OEM specification, on-site or in workshop depending on the unit.
Rising vibration, heat, noise or a creeping increase in power draw are the usual early signs. Vibration analysis and oil sampling turn those symptoms into a clear picture before a bearing or seal lets go.
Catch rotating-equipment faults before they fail. Alignment, balancing and overhaul, done properly.
Or email Service@oms-au.com
Objective Maintenance Solutions