Mechanical seals, bearings, alignment and fault finding for industrial pumps across SE QLD — servicing, breakdown repairs and shutdown support.
A pump rarely fails on its own. A seal weeps, a bearing runs hot, an alignment drifts — and the failure follows from there. We service and repair industrial pumps the way rotating equipment should be handled: find the root cause, fix it to spec, and get the duty point back where it belongs.
We work centrifugal, slurry, multistage and positive-displacement pumps across water and wastewater, process, quarry and food sites — mechanical seal replacement, bearing renewal, shaft and coupling alignment, wear-ring and clearance checks, and vibration analysis to confirm it's running true before it goes back into service.
On a shutdown we'll work your pumps through the scope on schedule; on a breakdown we'll get to the cause fast. Either way it comes back aligned, balanced and recorded — not just bolted together.
Most pump downtime starts at the seal. Correct selection and fitting for the duty is the difference between months and years of run time.
A few thou of misalignment shortens bearing and seal life dramatically. We laser-align pump to motor and record it.
A baseline vibration read catches imbalance and early bearing wear before it turns into a wet, stranded pump.
Weeping seal, noise, lost head, tripping on overload — tell us what it's doing and we'll read the urgency.
We find the real cause — seal, bearing, alignment, wear or system — rather than swapping parts and hoping.
Rebuilt to spec, laser-aligned, vibration-checked and handed back with the numbers recorded for your file.
Repeat seal failures usually trace to alignment, the wrong seal for the duty, or a dry-run or flush problem — not the seal itself. We look at the cause so the replacement actually lasts.
Yes — laser alignment on site, recorded. Correct alignment is one of the biggest single wins for bearing and seal life.
Yes — centrifugal, slurry, multistage and positive-displacement pumps across water and wastewater, process, quarry and food applications.
Yes. Planning pump work into a shutdown is far cheaper than a mid-run failure — we scope it and resource it to your window.
Seals, bearings and alignment done properly — on site or in the workshop, across SE QLD.
Or email Service@oms-au.com
Objective Maintenance Solutions